WB Electronics

Support - Infinity USB Smart

	How to - Use the commandline interface

Infinity USB Smart - Commandline arguments

-name:name	Name of the device (Infinity USB Smart) to use, in a multi programmer invironment. Each device must be named before use. Uses default programmer if -name is left out.
-deviceno:X	(X = 0 to 255) - Device ID of the device to use, uses first available if left out.
-enablevcp	Enables the Virtual COM port, must be used with the –createcom command
-createcom:X	(X = 1 to 255) - Specifies the port number to create.
-nogui	Does not display any graphical user interface, mostly for use in service mode or on a server environment.
-frq:frequency	(3.58 \| 3.68 \| 6.00) - Chooses frequency. Defaults to 3.58 if left out.
-polarity:resetpolarity	(phoenix \| smartmouse) - Chooses resetpolarity. Defaults to phoenix if left out.

Examples
Creates a virtual com port Com3 in 3.58MHz phoenix mode for the first located Infinity USB Smart:

InfSmart.exe –enablevcp –createcom:3 –polarity:phoenix –frq:3.58

Creates a virtual com port Com3 in 3.58MHz phoenix mode for the first Infinity USB Smart:

InfSmart.exe –deviceno:0 –enablevcp –createcom:3 –polarity:phoenix –frq:3.58

Creates a virtual com port Com3 in 6.00MHz phoenix mode for the Infinity USB Smart named “My Infinity USB Smart”

InfSmart.exe –name:”My Infinity USB Smart” –enablevcp –createcom:3 –polarity:phoenix –frq:6.00