WB Electronics
Back
Support - Infinity 1.3 CM2
Hardware upgrade
· Guide for upgrading Infinity 1.3 with Cardmaster firmware

User forum
· Forum


Hardware upgrade - Guide for upgrading Infinity 1.3 with Cardmaster firmware
Cardmaster upgradeguide for Infinity


(Please notice: We'll no longer be able to deliver the cardmaster upgrade kit as of 1st of March 2003, this guide is therefore meant for customers who already have a kit).


This guide describes, step by step, how to upgrade an Infinity 1.3 programmer with the latest Cardmaster firmware (with support for both Silvercards, Funcards etc).


You'll need a the Cardmaster Upgrade Kit (contact us for availibility) a soldering iron, some tinsolder and a small flat screwdriver.


Step 1
Solder a 47 kOhm resistor (supplied in the upgrade kit) between the two points shown on the photo. Use either a leaded resistor,




or an SMD resistor, and make sure there's no shortcircuits between the 2 points.




Step 2
Remove the old firmwarechip with the screwdriver.




Step 3
Insert the new Cardmaster firmware chip, and make sure it's well seated in the socket. Notice the small marking on the chip, and make sure it's aligned correct.




Step 4
Everything is done, and you're ready to use the Cardmaster software which can be downloaded from the download page.
Copyright ©2001-2024 WB Electronics - All rights reserved - Privacy policy